|
PIANO ROLL
Randomizer Tool
The Randomizer creates random notes in the Step Sequencer, or Piano roll (depending on the selected window). The notes can be based on a chord map and the tool allows pan, velocity and pitch randomization, etc.
NOTES: 1. Several options (such as Length, Variation, Stack, etc.) are available only for the Piano roll
window. 2. Notes created by the randomizer have the length of the current snap. The Length and Variation controls won't work if SNAP is set to '(none)'.
|
Options
Pattern
This section lets you set up the options used when generating the random
notes (disable the section if you don't want to add random notes).
- Octave - Sets the base octave used when generating notes.
- Range - The octave range within which random notes are created.
- Key - Sets the base tone for notes.
- Scale - Here you can select the chord type that will be used as a base for creating notes.
- Length - Sets the note length used for the generated notes (this option is available only for the Piano roll). The Length control has no effect if the Piano roll SNAP
is set to '(none)'.
- Variation - Sets the note length variation for the generated notes (this option is available only for the Piano roll). Turn the wheel to left to make the notes equal or shorter
than the specified length. Turn to right to make notes equal or longer than the specified length (the middle position disables the length variance). The Variation control has no effect if the Piano roll SNAP is set
to '(none)'.
- Population - Specifies the amount of notes that will be generated. The more you turn this wheel to the right, the more the notes generated.
- Stack - Sets the note polyphony used for the generated sequence (this option is available only for the Piano roll).
- Random Portamento - If checked, the notes will have random values for the portamento switch (checked or not) in the Miscellaneous Channel Settings.
- Merge Same Notes - If checked, two or more consecutive notes of the same pitch will be merged into a single longer note.
- Seed - Click the back and forward arrows to generate random note combinations based on the settings above (in all selected channels for the Step Sequencer,
or the selected timeline section in the Piano roll). You can use this feature to generate various (seeded) combinations until you're satisfied with the result.
To hear the combinations you generate, hit the play button in the Transport panel before you bring up the Randomizer dialog (or you can also call
the Randomizer and then press (Space) to toggle play/stop mode).
Levels
Set up the options that will be used to randomize the levels (pan, velocity, etc.) for all selected notes/channels (disable the section if you don't want to randomize the note levels).
- Levels -
These wheels lets you select the note properties you want randomized and the amount of randomization (this applies to the note levels only, not automation events!). Each wheel has a range
from -100% to 100%. At 0% the levels are left at their original values.
- Reset Before Processing - Reset the note levels to their default values before randomizing.
- Bipolar - Check to randomize the note levels 'bipolar', i.e. the levels will be randomized to both higher and lower values than the original values (as opposed to shifting them only higher or only
lower depending on the wheel values).
- Seed - Click the back and forward arrows to randomize the note properties based on the settings above (in all selected channels for the Step Sequencer,
or the selected notes in the Piano roll). You can use this feature to generate various combinations until you're satisfied with the result. To hear the combinations you generate,
hit the play button in the Transport panel before you bring up the Randomizer dialog (or you can also call the Randomizer and then press
Space to toggle play/stop mode).
Action buttons
- Reset - Reset the tool to the default state.
- Accept - Accept changes and close the tool. Note, these changes can be subsequently undone using the Current project History or Ctrl+Z.
|