FL Studio Mobile


Use leveller to monitor levels and to make precise changes to volume level and panning. NOTE: If you are using this on the Master, make sure to put an instance at the end of the FX chain to monitor final output levels. Do not let the levels exceed 0 dB, otherwise your song may sound distorted or 'crackly' depending on how severe it is. This is called 'clipping'. Read more about it here.

To load presets tap the 'Default' (upper right) and choose from the Presets List.


There are two controls, the Level slider and Pan knob.

  • Level - Change level from -infinity (muted) to + 12 dB (each 6 dB is approx 2X the starting level, so 12 dB is 4X).
  • Pan - Left/Right panning.