FL Studio can function as a ReWire client with ReWire enabled hosts. When functioning as a ReWire client, FL Studio sends all of its audio output to the ReWire host (providing up to 16 individual stereo outputs). FL Studio synchronizes with the host transport controls (playback/stop, song position) and has ability to send and receive MIDI data from the host.
FL Studio ReWire has the following specific features:
Exported Audio Outputs
Outputs, when used as a ReWire client, FL Studio provides 16 stereo outputs (32 paired mono channels). By default the first output pair is assigned to the Master mixer track, which means the whole project mix is sent to the first output pair. You can change this combination to fit your needs. For example, you can assign each Mixer track to a separate output, thus assigning individual outputs to a maximum of 16 individual mixer tracks in the Rewire host.
Plugins being used in FL Studio with multiple outputs should have these outputs routed to individual mixer tracks, this way they will become individually available through the Mixer outputs to the Rewire host.
ReWire allows MIDI IN and MIDI OUT via the ReWire connection. The ReWire output bus appears as a regular MIDI output device in the MIDI Settings window of FL Studio.
The ReWire MIDI output is usually linked to port 10, but you can change this assignment to suit your needs (to use it, add a MIDI Out channel set to the same port).
MIDI input works by mapping the first 16 channels (in order) in the Step Sequencer to 16 unique MIDI channels. To control any of these channels, simply send MIDI from the host to the appropriate channel number in the ReWire MIDI bus.
FL Studio is launched automatically when a ReWire device is activated within the host (since Cubase™ always activates all existing ReWire devices, FL Studio is launched at the startup of Cubase™). Normally, there is no need to launch FL Studio from the shortcut after launching the host.
If the ReWire device is activated, but not used, FL Studio will use a minimum of additional system resources adding little to the CPU load.
However, if you don't intend to use FL Studio as a ReWire device, you can un-register the device (see below).
Registering/Unregistering the ReWire Device
You can register (enable) the FL Studio ReWire device by launching the Start Menu > Image-Line > Install Plugin Version shortcut. You will be prompted to install the VST plugin first. Click cancel on both boxes and confirm you want to register the ReWire device in the last box.
To unregister (disable) the FL Studio ReWire device, use the Start Menu > Image-Line > Uninstall ReWire Client shortcut.
If you're using a host that supports ReWire devices, and the FL Studio ReWire device is activated, launch FL Studio from the Start Menu shortcut to display the ReWire panel rather than the default interface window. Click the FL Studio logo to toggle the visibility of the FL Studio window inside the host (normally this window is displayed automatically after the ReWire panel is launched).
Not a Standalone Process
FL Studio is launched as a process inside the ReWire host. This means that the FL Studio window is 'linked' to the host application window, with the following consequences:
In most cases you'll need to follow these steps to get FL Studio running as a ReWire client in a compatible host: